Description

Please read this entire description BEFORE ordering so you're aware of our shipping time and return policies Leather Magazine Holder for belt or pocket carry. Fits Beretta 92, 96, M9 Ambidextrous, can be worn on either left or right. IMPORTANT: 1. We make each magazine holder when ordered and they typically take up to 5 BUSINESS days to fabricate and ship . Once shipped, you'll receive a tracking number Ebay . 2. Hand dyed leather can have variations in color and consistency. Sometimes slightly lighter, sometimes slightly darker. 3. Why is saddle tan slightly more expensive? Because it takes longer to fabricate a magazine holder with saddle tan. This handmade leather magazine holder can be worn on the belt, on the inside or outside of the belt, or used as a pocket holder for your extra magazine. It features a small sweat shield to protect your magazine from sweat and also helps protect your clothes from gun oil that might be on the magazine. This is handmade from 8 ounce leather, dyed black or Saddle Tan and finished with two coats of wax and acrylic sealant. This magazine holder has been doubled stitched at the stress points using 346 mil-spec polyester thread that virtually unbreakable. Features: Designed, fabricated and shipped from Columbus Ohio, USA. Molded specifically for the Beretta 92, 96, M9. Sweat shield to protect magazine from body moisture. Belt slots are cut at 1 1/2 inches. Custom belt slot sizes are available on request. We use 346 mil-spec polyester thread that's virtually unbreakable. Free shipping via First Class US Postal Service to US addresses. Tracking number provided when shipped. Magazine holder is designed for low profile, concealed carry, outside the waistband. Important information: Each magazine holder is fabricated when ordered, and can take up to 5 BUSINESS days to ship after purchase. Purchaser is solely responsible for determining the suitability of this magazine holder for their intended use, as well as determining legality with their local and state laws. This is a new magazine holder , specifically molded to fit the Beretta 92, 96, M9 magazine. Fit could initially be tight. Break-in might be required for optimum fit and retention. Instructions for easily and correctly breaking-in the holster are included. As these are handmade magazine holders , there can be cosmetic variations in color and stitching, and occasionally include small blemishes on the cowhide from insect bites, scars or brands. The Saddle Tan leather can show dark spots immediately after fabrication, but will even out within a few weeks Purchase is for magazine holder ONLY. Pictured gun(s) patches, backpack and other items are for illustrative purposes only, and are NOT included. Makers Marks, letters, numbers and symbols embossed on the back of the magazine holder , can be different from the images above, or missing entirely. These are used by us to identify the holster during and after fabrication, and do not show when the holster is being worn. Returns Returns are handled on a case by case basis, within 30 days of purchase Any potential return must be in the same new and unused condition you received it. Buyer is responsible for return postage. We will not accept ANY returns on holsters, or products, that have been intentionally "softened", including softening by excessive bending, flexing, stretching or using liquids. We will not accept returns on any holster that has been modified. Last revised: September 6. 2023